There are six ways to quickly replace an electric car shock absorber!
The shock absorber is supporting frame weight, ease the uneven road vibration and impact of electric vehicles, and the rapid decay of vibration, improve riding comfort, reduce the dynamic stress of each part of the car body, prolong the service life of vehicles. But for a long time there will be failures, such as shock absorption, attenuation, deformation, and even fracture. If the electric shock absorber may be caused by poor risk of electric vehicles can not support frame and "break", bring danger to road riding. Here is how to easily replace the shock absorber, so that love home, electric car mall today and share with you the old master's approach!
The rear shock absorber of electric vehicle can be divided into adjustable hydraulic shock absorber and spring hydraulic shock absorber. A good shock absorber is not only comfortable for riding through the pit, but also prolongs the service life of the electric vehicle.
1, in order to facilitate the demolition of the rear shock absorber, open the back barrel, the bucket first removed, due to shock absorption, disassembly space is limited, unloading bucket, easy disassembly.
2, the upper and lower fixed shock absorber is mostly non slip silk, after time erosion, screws will rust, difficult to dismantle, it is best to use rust remover to "capture" rust, to remove "help" a helping hand".
3. Support the big brace of the car to remove the shock absorption! General fixed damper top screw, split up and laborious, due to space limitations is not good ", please wear gloves to" work ", so as to avoid the bumps, the best selection of wrench to remove the screws, to avoid the" edge "eating round difficult to unload.
4, by contrast, shock absorber bracket screws removed easily, but also not hard, or use the sleeve wrench to remove, after the upper and lower screws are removed, if the screw is not good smoke, shake a fixed motor bracket, it is easy to get down.
5. Measure the length of shock absorption. The correct method of measurement is the center hole distance of the shock absorber. From the end of the damper head hole position using the ruler to measure the position of the length of the other port, the shock are not too long or too short. Short: big support, strenuous effort, low back, uncomfortable riding. Long: big support, unstable support, can not afford.
6. Check the size and start the installation. Before installing, you'd better apply the lubricating oil to the newly removed screws so that it can be easily installed. Shock absorber upper support, lower support screws must be tightened to prevent the screws from falling off. Some cars vary in weight, the damping effect is not the same, the weight will be hard spring, some shock absorber can be adjusted, can be adjusted appropriately.
Let love home electric mall proposed electric vehicles encounter bumpy shock absorber to ease the turbulence, such as shock reduction, or deformation, or shaft broken, requires the timely replacement of spring break, safety is the most important, money is secondary, check is necessary, safe electric car is really needed!